How To Level Ground Under Intex Pool
Do not place your pool on a deck, balcony, or platform. There should be four feet of space around the entire pool…
Water it down with a hose to make sure that it’s packed in there good.
How to level ground under intex pool. Take away all of the extra bumps in the ground and fill them into the holes. For intex pool owners that are setting their above ground pools on an unlevel concrete surface, you have to measure first how many inches your intex pool is. Leveling the ground for a swimming pool, here, the intex easyset soft side pool.
How do you prepare the ground for an intex pool? Drive a 3/8 rod (available at any hardware store) through the hole into the exact center. Tips for leveling your intex above ground swimming pool area with sand.
Cut a 2×4 at length that will sit just under top frame of pool, get your hydrolic floor jack, and get something solid underneath so it does not sink in ground. Building a sand base for your intex pool. My way the egyptian water leveling method.
Drill a 3/8 hole exactly in the center of the 2×4 assembly as shown below. Installing it is relatively straightforward, but it is important to lay something down underneath to prevent pooling water from damaging and destroying grass or creating large mud puddles. Fill up the pool with the.
Setup pool, place 1 1/2 or 2 pavers/patio blocks under the legs. Check for level ground by using an 8′ 2×4. To level ground for a pool, dig away slopes and high spots to make them level with lower areas.
One method for doing this is to use string and a device called a. The ground under your pool should be flat and level. Preparing a site for an easy set pool can be challenging.
I show you several methods. The ground must be compact and firm, so the pool should not be set up on mud, sand, or loose soil. The pool is only half fool so as not to dent the metal fr.
If you have no level areas, it pays to have a professional pool installer. They could collapse under the weight once you fill up your pool. Since most intex pools are fairly large, it can be difficult to make sure that the site is level.
Thus is the easiest way i found to level the legs on my pool while i am putting it up every spring. If you have more than a few inches drop, it is a good idea to level off the top side a. If it’s not packed tightly, the pool will shift, and you’ll have to do it all over again.
Check for level ground by using an 8′ 2×4 board, one that’s not warped, and lay it flat on the ground, up.